Kernel Multi Check - Setting Up Your Kernel GCUHb Multi-Function Monitoring System; Setting Date and Time

Setting Up Your GCUHb Multi-Function Monitoring
System Setting Date and Time
NOTE:
When you install the batteries into the meter every time or replace the batteries, the meter
will enter setting mode automatically. You can set correct time and date before you begin
testing.
6. When you finish
setting,the meter
will turn off
automatically in
30 seconds.
1. The meter will automatically
en
te
r
the
setting mode after you install the batteries.
8
3. Press “S” button to
obtain correct month.
4. Press “M” button to confirm the
month setting and shift to the date setting.
5. Repeat the same steps to set
the date,hour and minute.
2. The month will flash.