Kessel EasyClean - English

26 / 48
Table of contents
V 1.0
1 Introduction 28
1.1 Product description, general ............................................................................................. 28
1.2 System types ....................................................................................................................28
1.3 Type plate .........................................................................................................................29
1.4 Scope of supply ................................................................................................................29
1.5 General instructions on using these operating and maintenance instructions .................. 29
1.6 Component assemblies and functional properties ............................................................ 30
2 Safety 31
2.1 Correct use .......................................................................................................................31
2.2 Staff selection and qualication ........................................................................................31
2.3 Organisational safety measures ....................................................................................... 31
2.4 Risks caused by the product ............................................................................................. 32
2.4.1 Danger of slipping when emptying the system ................................................................. 32
2.4.2 Risk of infection when coming into contact with the wastewater ...................................... 32
3 Installation 33
3.1 Recommendations for the set-up location / operation ...................................................... 33
3.2 Setting up / installing the grease separator system .......................................................... 33
3.3 Fitting the inlet and outlet .................................................................................................. 34
3.4 Mounting the direct disposal pipe .................................................................................... 34
3.5 Fitting the SonicControl sensor (option) - F ...................................................................... 35
3.6 Initial lling and pressure test ........................................................................................... 36
4 Operation / emptying 36
4.1 Emptying system type A ....................................................................................................37
4.2 Emptying system type B ................................................................................................... 37
5 Technical data 38
5.1 Torques ............................................................................................................................. 38
5.2 Pre-conditions / basis for calculation ................................................................................ 38
5.3 Dimensional drawing and weight table ............................................................................. 39
6 Maintenance 40
6.1 Maintenance intervals ....................................................................................................... 40
6.2 Troubleshooting ................................................................................................................ 40