kewtechcorp.com
5
kewtechcorp.com
Safety
Before using the KT63 PLUS read this instruction manual carefully to ensure a safe
understanding of the symbols and use of the tester. See opposite page for a list of symbols
used on the product and in this manual.
A Warning identies hazardous conditions and actions that could cause bodily harm or death.
A Caution identies conditions and actions that could damage the instrument or cause
permanent loss of data.
Read Before Using
To prevent possible electrical shock, re, or personal injury:
• Use the product only as specied, or the protection supplied by the product can be
compromised.
• Do not use the product around explosive gas, vapour or in damp or wet environments.
• Do not use test leads if they are damaged. Examine the test leads for damaged insulation,
exposed metal, or if the wear indicator shows. Check test lead continuity.
• Use only Kewtech approved accessories such as test leads etc supplied with the instrument.
• Do not use the product if it is damaged.
• To be repaired by Kewtech or authorised Kewtech agents only.
• Do not apply more than the rated voltage between the terminals or between each terminal
and earth ground.
• Remove test leads from the tester before battery cover is removed.
• Do not operate the product with covers removed or the case open. Hazardous voltage
exposure is possible.
• Use only specied replacement fuse. Fuse type F0.5A, 500V, HRC 6.3 x 32mm
• Keep ngers behind the nger guards on the probes at all times.
• Connect the common test lead before the live test lead and remove the live test lead before
the common test lead.
• Use Personal Protective Equipment (approved rubber gloves, face protection, and ame-
resistant clothes) to prevent shock and arc blast injury where hazardous live conductors are
exposed.
To Next Page
Loading...
Need help?
General
