Push-assist Mode
■ Push-assist function may only be used while pushing the E-bike. Be aware of danger of
injury when E-bike wheels do not have ground contact.
◆Switching the Lighting On/Off
To switch on bike headlight, hold “ ” button for 2s. The display backlight brightness
is automatically reduced. In the same way, hold the “ ” button for 2s, the bike headlight
can be switched off while display backlight recover its brightness.
Switching the Lighting On/Off Interface
◆Power Assist Level Selection
Press "+" or "-" button to change the E-bike system assist level and change the motor
output power, The default assist level ranges from level “0” to level “5”, The output
power is zero on Level“0”. Level“1”is the minimum power. Level“5”is the maximum
power. When you reach “5”, press the "+" button again, the interface still shows “5”,
and blinks at“5”to indicate the power highest. After the power downshift reaches “0”,
press the "-" button again, the interface still shows “0” and blinks at “0”to indicate the
power minimum. The default value is level “1”.
To Next Page
Loading...
