2) Press to show the Trigger Sub-Panel.
3) Press to edit Trigger type, and then select to set Trigger type to MANUAL.
4) Rotate to select the Source trigger source and press to edit it.
5) Press to toggle the Assist keys, and then press to set the Source trigger source
to EXT1.
6) If you are not on the top Function menu, press repeatedly until you are back at the top level.
At the top level of the Function menu
No tree structure is visible
A tree structure is visible
At a lower level in the Function menu
19 | Keysight | Sourcing Precise Current/Voltage Sinusoidal Waveforms Using the B2961A/62A – Demo Guide
To Next Page
Loading...
