3 Calibration Procedures
58 Keysight E3633A and E3634A Service Guide
Programming
Most performance tests can be performed from the front panel. However, an GPIB
or RS-232 controller is required to perform the voltage and current programming
accuracy and readback accuracy tests.
The test procedures are written assuming that you know how to program the
power supply either from the front panel or from an GPIB or RS-232 controller.
Complete instructions on front panel and remote programming are given in the
Keysight E3633A and E3634A User’s Guide.
To Next Page
Loading...
Need help?
General
