Keysight N5991 HDMI Frame Generator
User Guide
2 Test Instrument Setup
M8195A Single Module setup / 10
M8195A Two Module setup / 11
Prior to using the HDMI Frame Generator software for connecting
instruments, Keysight recommends setting up the test instruments and
establishing the required connections.
1 Connect the instruments (AWG and other instruments, such as, signal
and waveform generators) to the controller PC via USB or LAN.
2 Establish all required cable connections between the instruments and
the DUT (device under test).
3 Switch on the PC and instruments.
4 Start Keysight “IO (Input Output) VISA (Virtual Instrument Software
Architecture) connection Expert” and check the connections for the
instruments.
5 Set the correct IP addresses for the instruments.
The AWG setup can be used in two different configurations:
• based on single M8195A module (TMDS only)
• based on two M8195A modules and an M8197A synchronization
module
To Next Page
Loading...
