14 X-Series Signal Analyzers Getting Started and Troubleshooting Guide
Quick Start
Turning on the Analyzer the First Time
7. Verify the installation a. On the instrument, press
System, Show
System.
b. Verify that the
purchased
application(s) appear in
the list or have an
entitlement certificate.
If you require further assistance, contact the Keysight
support team.
Online assistance: http://www.keysight.com/find/assist
8. View a signal
a. Press
Input/Output,
RF Calibrator, 50
MHz.
b. Press
FREQ, Center
Freq
, 50, MHz.
c. Press
SPAN, 50, MHz.
This routes the internal 50 MHz signal to the analyzer
input.
Steps Actions Notes
To Next Page
Loading...
