X-Series Signal Analyzers Getting Started and Troubleshooting Guide 77
Using Windows Tools
Embedded Web Server: Using the X-Series Signal Analyzers Remotely
Controlling the Instrument
Selecting this tab enables you to view, control and interact with the instrument
through the web server.
Table 4-9 Selecting the Control Instrument tab
Step Notes
1. Select
Control Instrument
A password entry dialog appears.
By default, this password is set at the factory as
“measure4u”. However, you may subsequently change
the password. (Select
System, I/O Config, Web
Password
Reset on the instrument front panel to
change the password.)
When the correct password has been entered, the
Control Instrument web page appears.
2. You can now enter new settings
as required.
To Next Page
Loading...
