16 X-Series Signal Analyzers Getting Started and Troubleshooting Guide
Quick Start
Instrument Power Down Process
Instrument Power Down Process
The following steps ensure that your data is saved before the instrument shuts
down.
Recommended instrument shut down
Step
1. Briefly press the front panel power button.
Do not hold the button down (since this signals the processor
to immediately shut down before saving data, which could
potentially cause disk corruption).
2.
The instrument will begin the power down sequence where the instrument
performs clean-up activities such as closing applications and writing data to
disk. The “Shutting Down” Message will appear on screen.
Do not disconnect the AC power at this time. It is important
that the instrument be able to complete all power down
activities before power is interrupted.
3.
When the display goes blank, the fans stop, and the front panel yellow standby
light turns on,
the instrument is completely shut down.
4. You may safely remove the power cable at this time.
To Next Page
Loading...
Need help?
General
