20 X-Series Signal Analyzers Getting Started and Troubleshooting Guide
Quick Start
Instrument Information
Cleaning Connectors
Cleaning connectors with alcohol shall only be done with the instrument power
cord removed, and in a well-ventilated area. Allow all residual alcohol moisture
to evaporate, and the fumes to dissipate prior to energizing the instrument.
Battery Information
The analyzer uses a lithium battery located on the CPU board. This is not an
operator replaceable part. See “Returning an Analyzer for Service” on
page 87. Replaceable parts must be approved or supplied by Keysight
Technologies.
Keep isopropyl alcohol away from heat, sparks, and flame. Store in a tightly
closed container. It is extremely flammable. In case of fire, use alcohol foam, dry
chemical, or carbon dioxide; water may be ineffective.
Use isopropyl alcohol with adequate ventilation and avoid contact with eyes,
skin, and clothing. It causes skin irritation, may cause eye damage, and is harmful
if swallowed or inhaled. It may be harmful if absorbed through the skin. Wash
thoroughly after handling.
In case of spill, soak up with sand or earth. Flush spill area with water.
Dispose of isopropyl alcohol in accordance with all applicable federal, state, and
local environmental regulations.
Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type recommended. Discard used batteries according to the
manufacturer’s instructions.
Do not throw batteries away but collect as small chemical waste.
To Next Page
Loading...
Need help?
General
