Keysight 33210A - Page 248

246
Chapter 4 Remote Interface Reference
Interface Configuration Commands
4
SYSTem:COMMunicate:LAN:TELNet:WMESsage < string >
SYSTem:COMMunicate:LAN:TELNet:WMESsage?
Sets the welcome message seen when using a Telnet session to
communicate with the 33210A. The default welcome message is
“Welcome to
Keysight’s 33210A Waveform Generator”.
• The 33210A uses LAN port 5024 for Telnet sessions.
• The message is a quoted string of up to 63 characters.
• The welcome message is stored in non-volatile memory, and does not
change when power has been off, or after an instrument reset (*RST).
LAN Port Usage The Keysight 33210A uses LAN port 5024 for Telnet
sessions, but uses LAN port 5025 for Socket sessions. For further
information on socket sessions, see the white paper “Socket Connections
for LAN-enabled Instruments” found on the
Keysight 33210A Product
Reference CD.
33210A users guide.book Page 246 Wednesday, July 16, 2008 11:16 AM