Keysight 33210A - Page 287

285
Chapter 5 Error Messages
Execution Errors
4
5
-221 Settings conflict;
amplitude changed due to offset
The relationship between output amplitude and offset voltage is shown
below. Vmax is the maximum peak voltage for the selected output
termination (5 volts for a 50Ω load or 10 volts for a high-impedance load).
If the existing amplitude is not valid, the function generator will
automatically adjust it to the maximum value allowed with the offset
voltage specified.
Vpp <
2 X (Vmax – |Voffset|)
-221 Settings conflict;
low level changed due to high level
You can set the levels to a positive or negative value, but note that the
high level must always be greater than the low level. If you specify a high
level that is less than the existing low level, the function generator will
automatically set the low level to be 1 mV less than the high level.
-221 Settings conflict;
high level changed due to low level
You can set the levels to a positive or negative value, but note that the
high level must always be greater than the low level. If you specify a low
level that is greater than the existing high level, the function generator
will automatically set the high level to be 1 mV greater than the low
level.
-222 Data out of range;
value clipped to upper limit
The specified parameter is outside of the function generator’s capability.
The function generator has adjusted the parameter to the maximum
value allowed. Example: PHAS 1000
-222 Data out of range;
value clipped to lower limit
The specified parameter is outside of the function generator’s capability.
The function generator has adjusted the parameter to the minimum
value allowed. Example: PHAS -1000
33210A users guide.book Page 285 Wednesday, July 16, 2008 11:16 AM