Keysight 33210A - Page 292

290
Chapter 5 Error Messages
Execution Errors
5
-222 Data out of range;
FM deviation limited by maximum frequency; value clipped to
upper limit
The frequency deviation cannot exceed the carrier frequency, and is
limited as follows: 5 MHz for sine or square wave carriers.
-222 Data out of range;
PWM deviation
The PWM deviation is limited. Width deviation can be from 0 to the
width of the underlying pulse waveform. Duty cycle deviation can be
from 0 to the duty cycle of the underlying pulse waveform. Both are
further limited by the minimum pulse width and edge time parameters.
-222 Data out of range;
PWM deviation limited by pulse parameters
The PWM deviation is limited by the current pulse parameters. The
PWM deviation (width or duty cycle) is set to accommodate the current
pulse width or duty cycle, edge time, and period.
-222 Data out of range;
duty cycle; value clipped to ...
The square wave duty cycle is limited to values between 20% and 80% by
instrument hardware.
-222 Data out of range;
duty cycle limited by frequency; value clipped to upper limit
The square wave duty cycle is limited to values between 40% and 60%
when the frequency is greater than 5 MHz.
Duty Cycle: 20% to 80% (to 5 MHz)
40% to 60% (to 10 MHz)
-223 Too much data
An arbitrary waveform was specified that contains more than 8,192
waveform points. Verify the number of points in the DATA VOLATILE or
DATA:DAC VOLATILE command.
-224 Illegal parameter value;
An exact parameter value, from a list of possible values, was expected.
33210A users guide.book Page 290 Wednesday, July 16, 2008 11:16 AM