Getting Started 1
Keysight 34980A Getting Started Guide 21
Removing a Slot Cover
Your 34980A is shipped from the factory with one slot uncovered and the
remaining seven slots covered. When performing tasks in this guide to become
familiar with the instrument, you will install a plug-in module into Slot 1. When
you are ready to install additional modules, follow the procedure below to remove
a slot cover.
Using a flatblade screwdriver, pry each side of the slot cover until the cover
releases from the slot. With the slot cover removed, you can now install a module
in this slot.
Under certain conditions, dangerous voltage levels capable of causing injury
or death may remain even after external circuits have been disconnected. To
avoid electrical shock, remove the main power cord from the 34980A and
ensure all connections to the DUT, including field wiring to the instrument
and the analog bus (if present) are deenergized and all circuits are
discharged before coming in contact with the system. Ensure no hazardous
voltages remain on any accessible before handling any part of the
instrument and test setup, making connections to the system, removing
covers or cleaning the instrument.
To Next Page
Loading...
