Getting Started 1
Keysight 34980A Getting Started Guide 23
Installing a Module
Installing a Module for Use with Cables
If you are planning to use cables for your external connections, follow the
procedure below to install a plug-in module. If you are planning to use an optional
terminal block to connect your external wiring, see the procedure on page 24.
1 Install the module into a mainframe slot until it fully seats with the backplane
connector.
2 Using a Pozidriv #1 screwdriver, tighten the two screws to secure the module
in the mainframe. Installation is now complete.
NEXT STEP: Go to “Operating the Front Panel Keyboard” on page 34.
The Safety Interlock feature prevents connections to the Analog Buses if no
terminal block or properly-wired cable is connected to a module (available on
the multiplexer and matrix modules only). If the proper connections are not
present, the Analog Bus relays will be disabled on that module and the front
panel “Safety Interlock” display annunciator will turn on. See the 34980A User’s
Guide for additional information.
To Next Page
Loading...
