Contents
1. File
• How to save the data
• How to load the data
• What types of data formats are supported on the CX3300 ?
• How to save rarely occurring waveforms automatically
2. Setup
• How to change the horizontal scale and position
• How to change the sampling rate
• How to change the memory depth
• How to change the 14-bit or 16-bit resolution
• How to change the vertical scale and position
• How to change the current range
• How to set the bandwidth limit
• How to minimize the offset current
• How to perform a Skew adjustment
• What determines the effective bandwidth of the instrument ?
• How to zoom in on the waveform
• How to use the waveform memory
• How to overlay multiple acquisitions
• How to display the secondary Y axis
3. Trigger
• How to set the trigger
4. Measure
• How to apply a Measurement Function
• How to apply the A-B marker
• How to place pointers on waveforms
• How to add an Annotation
5. Analyze
• How to apply the post-filter
• How to perform the FFT ( Fast Fourier Transform )
• How to analyze the waveform in the specified area with an Area marker
• How to apply the Power and Current Profiler
• How to apply the XY analysis
6. Utilities
• How to change the measurement units (Clone to Ampere Hour) in Area
analysis
• How to perform User calibration
• How to check the firmware revisions
• How to simulate the 50 MHz or 100 MHz bandwidth option on the
mainframe with the 200 MHz option
• Where to find the Online help
• How to display the menu bar
To Next Page
Loading...
Need help?
General
