EasyManua.ls Logo

Keysight E4991B - Page 5

Keysight E4991B
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Impedance Analyzer 3
Manufacturer’s Declaration
Herstellerbescheinigung
GERA USCHEMISSION
LpA < 70 dB
am Arbeitsplatz
normaler Betrieb
nach DIN 45635 T. 19
Manufacturer's Declaration
ACOUSTIC NOISE EMISSION
LpA < 70 dB
operator position
normal operation
per ISO 7779
Regulatory Compliance Information
This product complies with the essential requirements of the
following applicable European Directives, and carries the CE
marking accordingly:
The Low Voltage Directive 2006/95/EC
The EMC Directive 2004/108/EEC
To obtain Declaration of Conformity, please contact your local
Keysight Technologies sales office, agent or distributor.
Safety Notice Supplement
This equipment complies with EN/IEC61010-1:2010.
This equipment is of MEASUREMENT CATEGORY I (CAT I). Do
not use for CAT II, III, or IV.
This equipment is a POLLUTION DEGREE 2, INDOOR USE
product.
This equipment is tested in stand-alone condition and in
combination with the accessories supplied by Keysight
Technologies against the requirement of the standards
described in the Declaration of Conformity. If it is used as a
system component, compliance of related regulations and
safety requirements are to be confirmed by the builder of the
system.
Do not connect the measuring terminals to mains.

Other manuals for Keysight E4991B

Related product manuals