43
Saving Data
Overview
returns back to the Export Data menu and the selected Correction
number is annotated on the key. See “Correction Data File” on
page 44.
Trace The trace file contains "meta" data which describes the current
setting of the receiver, but it is not the full state of the receiver.
You can select Traces 1, 2 3, or All. You cannot recall a trace file
that was saved with "All" selected. See the following:
“Frequency Scan Trace Data File” on page 45.
“Strip Chart Trace Data File” on page 46
“Monitor Spectrum (IF Mode0 Trace Data File” on page 47
Limit Limits may be exported into a data file with a .csv extension. They
may be imported from that data file; they may also be imported
from a legacy limit file with a .lim extension. The .lim files meet
the specification for limit files contained in the EMI measurement
guide, HP E7415A. See “Limit Data Files” on page 47.
Signal List A Signal List file contains a copy of one of the signal lists
obtained during measurement. See “Signal List Data Files” on
page 49.
Scan Table A Scan Table file contains a copy of one of the files obtained
during a measurement.
Meas Results In the Frequency Scan measurement, the Meas Result file is in the
format of .html or .pdf. It is a report that contains the measurement
result. You can configure the content using either the setup form
or softkeys. Using a mouse and keyboard may make filling out the
form easier, but you can also accomplish the task through the front
panel keys. The checkboxes or radio buttons on the setup form are
tied to the corresponded softkeys as you select them. See “Meas
Results Data Files” on page 50.
Data file examples
Most of the files are text files in .csv (comma separated values) form, to make them
importable into Excel or other spreadsheet programs. The data follows the DATA
row, as comma separated X, Y pairs; one pair per line.
To Next Page
Loading...
