12 M8000 Series of BER Test Solutions Tips for Preventing Damage
1 Tips for Preventing Damage
Connecting & disconnecting 1.0 mm cables
Tools required to connect/disconnect the cable
• 8710-2812 Torque Wrench: 4-in-lb 6 mm
Table 7 Steps to connect / disconnect the cables
Steps to be performed Reference image of the cable
Connecting the cables
Loosen the grooved nut (position 1) and
confirm the screw thread is visible. The
center pin is now retracted from the
standard position.
Use 8710-2812 wrench to tighten the Hex
nut (position 2) to the female connector of
the module.
Use 8710-2812 wrench again to tighten
the grooved nut (position 1). Do not use
the wrench on the threaded nut (with red
X). The center pin will extend into the
female connector’s socket to secure the
connection.
Disconnecting the cables
Use the 8710-2812 torque wrench to
loosen the grooved nut and confirm that
the screw thread is visible (position 1). The
center pin is now retracted from the
standard position.
Use the 8710-2812 torque wrench to
loosen the hex nut (position 2) from the
female connector of module or device.
Avoid repeated bending of cables; a single sharp bend can damage a
cable instantly.
To Next Page
Loading...
