Keysight N9912A - Tests and Adjustments; Information in this Chapter; Chapter Three At-A-Glance

3-1
Keysight N9912A RF Analyzer
Service Guide
3 Tests and Adjustments
Information in This Chapter
This chapter contains procedures to help you check, verify, and adjust your
N9912A analyzer.
— The checks verify the operation of the assemblies in your analyzer.
— The adjustments allow you to tune your analyzer for maximum response.
Chapter Three at-a-Glance
The Keysight N7841A software package is required to test and adjust your
analyzer. This software package must be purchased separately. It can be
downloaded from the Internet and a license purchased on-line, or it can be
ordered on a CD-ROM. Go to www.keysight.com/find/calibrationsoftware
for further information. The help file for the N7841A software package is
also available at this URL.
Section Title Summary of Content Start Page
Before You Begin Items to consider or procedures to perform before testing is begun:
— Verify the operating environment.
— Protect Against Electrostatic Discharge (ESD)
— Allow the Analyzer to Warm Up
— Review the Principles of Connector Care
page 3-3
Service Test Equipment A list of additional equipment recommended for servicing the N9912A
analyzer.
page 3-5
Before Returning an
Instrument to a
Customer
A list of things to do before returning an instrument to a customer
after servicing is completed.
page 3-6
Operational Check An operation check that should be performed before returning an
instrument to a customer.
page 3-7
Performance Tests
(Keysight N7841A
Software Package)
a
A list of performance tests included in the Keysight N7841A software
package.
page 3-8