Keysight N9912A Service Guide 7-7
Repair and Replacement Procedures
Removing and Replacing the Case Group Parts
Removing and Replacing the Case Group Parts
Tools Required
— T-8 TORX driver (set to 6 in-lb)
— T-10 TORX driver (set to 9 in-lb)
— Isopropyl alcohol (Use only in a well ventilated area.)
— Repair and Re-assembly Kit. Refer to “Miscellaneous Parts” on page 6-12.
Replacing the Kickstand, Hinge Cover, and Hinge
1. Remove, and discard, the four screws (item 1) from the kickstand hinge
cover. New screws are provided in the Repair and Re-assembly Kit.
Figure 7-2 Replacing the Kickstand and Hinge Cover
Before beginning any repair, disconnect the power cord.
To Next Page
Loading...
