Keysight N9912A - Removing and Replacing the Main Battery

7-6 Keysight N9912A Service Guide
Repair and Replacement Procedures
Removing and Replacing the Main Battery
7-
Removing and Replacing the Main Battery
Tools Required
None
Replacing the Main Battery
1. Disconnect the power cord.
2. Remove the battery compartment door by pushing in on the detent and
then sliding the door downwards.
3. Note the orientation of the battery for installation of the replacement.
4. Remove the old battery and install the new battery in the battery
compartment.
5. Reinstall the battery compartment door by aligning it in position and then
sliding it upwards until an audible click is heard.
Figure 7-1 Replacing the Main Battery
Refer to “Battery Disposal” on page 1-8 for important instructions on
disposing of the old battery.