Keysight U1241B - Setting Configurations

3 Default Setting Configurations
48 Keysight U1241B and U1242B User’s and Service Guide
Setting Configurations
1 Turn off the multimeter.
2 From OFF position, press and hold (Setup) while turning the rotary
switch to any non-OFF position.
To change a menu item setting in Setup mode, perform the following steps:
1 Press or to scroll through menu items.
2 Press or to scroll through available settings. See Table 3-1 for the
details of each available option.
3 Press (Save) to save the changes. These parameters remain in the
non-volatile memory.
4 Press and hold (Setup) for more than one second to exit Setup mode.
NOTE
After you hear a beep, the multimeter is in Setup mode and you can release
button.