3 Default Setting Configurations
50 Keysight U1241B and U1242B User’s and Service Guide
rSt Reset dFAU Resets the multimeter to the factory settings by
pressing and holding for more than 1
second. A beep sound indicates the reset is being
done.
dFAU
Temperature
[c]
d-CF Sets temperature measurement to °C, pressing
to change measurement unit to °F
d-CF
[d]
d-F Sets temperature measurement to °F
d-FC Sets temperature measurement to °F, pressing
to change measurement unit to °C
d-C Sets temperature measurement to °C
[a] To activate the multimeter after it has auto power off, press any button to resume back to respective functional mode.
[b] The firmware is factory-installed and is not field-upgradeable.
[c] To view Temperature ( ) menu, press for more than one second.
[d] After this setting has been changed, resetting the multimeter will not revert it to the original default factory setting. The current setting will be
the new default setting.
Table 3-1 Available setting options in Setup mode (continued)
Menu item Available setting options Default factory
setting
Setup Description Selection Description
To Next Page
Loading...
