AIR CONDITIONER FEATURES(CONTINUED)
FOLLOW ME FEATURE:
Auto
Low
Med
!(_)___ High
j Light flashing
/
NOTE:
This feature can be activated from the remote
control ONLY. The remote control serves as a
remote thermostat allowing for the precise
temperature control at its location.
To activate the Follow Me feature, point the remote
control towards the unit and press the Follow Me
button. The remote display is actual temperature
at its location. The remote control will send this
signal to the air conditioner every 3 minutes interval.
If the unit does not receive the Follow Me signal
during any 7 minutes interval, the unit will beep to
indicate the Follow Me mode has ended.
The actual temperature can be displayed at the unit
by pressing the Fan Only mode. When in the Cool
mode, the unit display indicates the set temperature.
ADDITIONAL THINGS YOU SHOULD KNOW
Now that you have mastered the operating procedure, here are more features in your control that
you should become familiar with.
• The Cool circuit has an automatic 3 minutes time delayed start if the unit is turned offand on
quickly. This prevents overheating of the compressor and possible circuit breaker tripping
The fan will continue to run during this time.
• The control will maintain any set temperature within 1°F, between62°F(17°C)and86°F(30°C degrees.
• The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius.
To convert from one to the other, press and hold the Left and Right Temp/Timer buttons at the
same time for 3 seconds.
Air Directional Louvers
Lever
Air Direction
The louvers will allow you to direct the air flow
Left or Right throughout the room as needed.
Move the Levers from side to side until the desired
Left/Right direction is obtained.
9
To Next Page
Loading...
