Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2019 Krueger International, Inc. All Rights Reserved • Code KI-AI-000059/KI/PDF/1219
700 Series, Connection Zone Collection & U-Series - Optional Laminate Worksurface
Assembly Instructions
Optional Laminate Top
Assembly (cont.)
6. Apply 3” long strips of
double-sided tape to top corners
of the storage unit, about
1
/
4
”
from the edges of the front and
back of each side as illustrated
(Figure 4 & Detail B).
7. Remove the backing from the
double-sided tape, which were
adhered to the storage unit tops
in the previous step. Carefully
center the laminate top over the
storage unit(s) such that the top
overhangs the storage unit by
1
/
16
” on all sides, then set the
laminate top onto the storage
unit(s) (Figure 5).
Note: For the step below, it is
advised to either have a second
person press down on the
laminate top while driving in
each screw, or pre-drill each hole
using a
7
/
64
” drill bit to no deeper
than
1
/
2
” before driving in screws.
8. Assure that the laminate top is
properly aligned on the storage
unit(s). Then, from inside the
storage unit(s) at the pre-drilled
holes, use a power drill with #3
Phillips tip and #14 x
7
/
8
” Phillips
Pan Head screws to secure the
storage unit top(s) to the laminate
top at each corner, and at the
on-center front and back
locations, if applicable
(Figure 5 & Detail C).
9. Re-install the drawers if removed
in step 4.
laminate
worksurface
cordless
phillips pan-head
screw
8
6
storage
unit (top)
1
/
”
4
1
/
”
4
1
/
”
4
1
/
”
4
Detail B
double-sided
tape
1
/
”
4
4
laminate
worksurface
storage
unit (top)
Detail C - Storage Units with Laminated Tops
42” and Wider or 18” and Deeper
#14 x /”
phillips pan-head
screw
7
8
cordless
power
drill
laminate
worksurface
To Previous Page
