Need help?Do you have a question about the KI Balance and is the answer not in the manual?
Instructions for engaging offset tabs and fastening brackets with machine screws.
Steps for hanging on-module overhead units by engaging teeth into panel frame slots.
Instructions for hanging WireWorks off-module units, including tile preparation.
Procedure for hanging overhead units onto a load bar by hooking the mounting bracket.
Guide to positioning upmount brackets on a 54" WireWorks panel at a specific height.
Aligning cabinet slots with bracket slots and tightening screws.
General| Category | Indoor Furnishing |
|---|---|
| Worksurface Shape | Rectangular |
| Adjustment Type | Electric |
| Material | Laminate, Steel |
| Color | Various |
To Next Page
