Need help?Do you have a question about the KI Unite Panel System and is the answer not in the manual?
General overview of Unite Panel System frames and their construction.
Details on securing Unite frame intersections using connector blocks.
Explanation of connector blocks and their pre-assembled spacer plates.
Information on end-of-run trim clips used for attaching frame end trim.
Instructions for assembling Unite panel frames at 90° and 120° intersections.
Procedure for assembling 120° Unite panel frame intersections, including light shields.
Steps for assembling Unite panel frames at intersections with different heights.
Instructions for connecting Unite panel frames in a straight line.
Steps for connecting 180° Unite panel frames in-line, without light shields.
Instructions for assembling full-height stacking sections at intersections.
Procedure for assembling steel stacking sections at full-height intersections.
Guide for installing aluminum stacking sections at end-of-run and in-line configurations.
Procedure for installing steel stacking sections at end-of-run and in-line.
General introduction to stacking section installation and types.
Instructions for assembling aluminum stacking sections.
Installing aluminum stacking sections at full-height intersections.
Instructions for assembling steel stacking sections.
Guide for installing steel stacking section intersection kits.
Procedure for assembling steel stacking sections at full-height intersections.
Instructions for installing tiles into steel stacking sections.
Procedure for installing top caps onto stacking sections.
Instructions for installing end-of-run trim clips to hold vertical trim in place.
Installing end-of-run trim clips on panel frames with height changes.
Installing in-line change-of-height trim and intersection caps for gallery panels.
Procedure for installing dead-end change-of-height trim for gallery panels.
Instructions for installing end-of-run change-of-height trim for gallery panels.
Steps for installing the base raceway trim to panel frames.
Guide for installing the lifted base shroud.
Instructions for installing vertical intersection trim at panel frame connections.
Steps for installing end-of-run change-of-height trim.
Procedure for installing top caps onto panel frames.
Installing vertical trim for end-of-run and change-of-height panel frames.
Steps to start perpendicular Unite panel frame connections to Genius Wall.
Installing Unite stacking sections to Genius Wall perpendicularly.
How to start universal Unite panel frame connections to Genius Wall.
General introduction to electrical component installation for the Unite system.
Instructions for installing vertical 10-wire jumpers between wireways.
Procedure for installing horizontal 10-wire panel-to-panel jumpers.
Steps for installing 10-wire duplex receptacles into rigid wireways.
Guide for installing the 10-wire base raceway power infeed.
Procedure for installing the 10-wire lifted base power infeed.
Instructions for installing the 10-wire top power infeed assembly.
Steps for installing the New York City base power infeed.
Guide for installing the New York City top power infeed.
Installing Chicago hardwired base power infeed for 24 and 30 inch panels.
Steps for installing Chicago hardwired base power infeed for 36-72 inch panels.
Instructions for installing end-of-run dual/single-sided gallery panels.
Guide for installing dual-sided, two-piece gallery panels.
Steps for installing divider intersection posts for gallery panels.
Guide for installing fabric tiles into panel frames.
Instructions for installing steel and markerboard tiles.
Procedure for installing slat wall tiles into panel frames.
Steps for installing tile-to-floor tiles into panel frames.
Guide for installing split tiles into 72-inch panel frames.
Instructions for assembling segmented frames with aluminum stacking sections.
Procedure for installing tiles into steel segmented frames.
General instructions for installing glass dividers into panel frames.
Steps for installing glass dividers that span across two panel frames.
General| Category | Indoor Furnishing |
|---|---|
| Type | Panel System |
| Panel Thickness | 2 inches |
| Material | Fabric |
| Mounting Options | Freestanding, Wall-mounted |
| Color Options | Multiple options available |
To Next Page
