Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
3
Balance
®
Overhead Cabinet
Assembly Instructions
On-Module Mounted
Overhead Units
1. The On-module mounting brackets
have integral teeth that engage the
vertical furniture hanging slots in the
panel frame. Locate the on-module
overhead unit at the height that is
desired on the panel. Engage the
upturned tooth of the top hook
(circled) into the panel frame by
holding the cabinetbottom out about
30°, then rotate the unit to engage
all the remaining teeth. When all
teeth are engaged, press down on the
cabinet to lock in place (Figure 2).
Caution: To remove the overhead
unit from the panel, push the bottom
of the cabinet straight up about
1
/
4
”
and rotate the bottom out toward
you to about 30°. Pull the overhead
straight out and down. Do not force
the side panel, damage to the top
tooth may result.
on-module
overhead
upturned
tooth
On-Module
mounting
bracket
To Next Page
Loading...
