KIC SPS Smart Profiler User Manual

SPS Smart Profiler
Hardware Guide
Publication Number PTG-330310-000 Rev. C

KIC SPS Smart Profiler Specifications

General

Brand	KIC
Model	SPS Smart Profiler
Category	Data Loggers
Language	English

Summary

Introducing the SPS Smart Profiler

Review Your Profiler Kit

Your Smart Profiler Software

Overview of the Profiling Software 2G and its capabilities for thermal profiling.

SPS Smart Profiler Hardware Initialization

Warranty Protection Impairment

Warning about improper handling potentially affecting warranty and equipment protection.

The SPS Smart Profiler LEDs

The Smart Dock LEDs

Power the SPS Smart Profiler

Battery LED Behavior

Explanation of battery status indicators on the SPS Smart Profiler.

The Power Button

Instructions for using the power button for turning on/off and hard resetting the device.

Set Up the SPS Smart Profiler

Choosing the Mode of Profiling

Datalog Mode

Step-by-step guide to configure the SPS Smart Profiler for datalogging.

Wireless Mode

Step-by-step guide to configure the SPS Smart Profiler for wireless communication.

Hardware Status: LED Status Window

Using the Thermal Shield

Safe Handling after Exiting the Oven

Safely Remove the Profiler from the Oven

Procedure for safely removing the hot profiler from the oven.

Safely Remove the Profiler from the Shield

Procedure for safely removing the profiler from its thermal shield.

Specifications and Environmental Conditions

Regulatory Compliance

Calibrating the SPS Smart Profiler

Establish communication

Steps to establish communication between the profiler and the computer for calibration.

Specify the CJREF Offset

Procedure to set the Cold Junction Reference (CJREF) offset value for accurate temperature readings.

Specify the Gain Adjustment

Procedure to adjust the Gain setting for maximum accuracy across the profiler's temperature range.

Contact KIC