SPS Smart Profiler Hardware Guide PTG-330310-000 Rev. C
3
SPS Smart Profiler Hardware Initialization
To begin profiling in either datalog or Wi-Fi mode, you must first set up your SPS Smart Profiler for use on your
PC. Both modes communicate to the computer through a standard USB port – datalog mode uses a cable,
Transmitter (Wi-Fi) mode uses the Smart Dock. If the computer has no available USB ports, use a standard 2-8 port
hub to add an open port.
Note: Install Profiling Software 2G BEFORE connecting the SPS Smart Profiler hardware to the
computer. Connecting the hardware before the software is installed may result in Windows OS
selecting the incorrect driver for the device and it will not connect to the software.
The normal setup routine must follow the sequence shown below:
1. Install the software.
2. Install the USB security dongle.
3. Connect the SPS Smart Profiler hardware to the computer.
Note: When connecting the SPS Smart Profiler to laptop computers that utilize a floating ground
connection (2-prong power plug) manually ground the laptop before connecting the SPS Smart
Profiler. This procedure will prevent unwanted electrical interference that may distort the temperature
data collected by the SPS Smart Profiler.
If you have any questions or need assistance connecting your hardware, contact KIC Technical Support
tech@kicmail.com.
Warranty Protection Impairment
Caution: RISK OF VIOLATION OF WARRANTY
Improper handling may limit our liability for damage to equipment and may also violate your
instrument warranty. As well improper handling or use could impair the protection provided by
the equipment.
To Next Page
Loading...