Kidde Gemini II - Page 109

E-7November 2002 06-235975-001
Kidde Gemini II System
Figure E-7 (con't.) Release Circuit and Stop Valve Terminal Detail
GENERAL RELEASING NOTES:
370
340
220
800
570
18 AWG
480A 1440 760
FM
SOLENOID
GROUP
500
760
940
1570
B,D
E,G
300
525
RELEASING
DEVICE
899175
48650001
SOLENOID
890181
14 AWG
WIRE LENGTH (FT.)
2000
1460
200
200
300
3000
2300
12 AWG
300
120
1200
915
16 AWG
120
PART NO.
MAXIMUM OF ONE #12 AWG WIRE PER TERMINAL.
2. RELEASING OUTPUT DEVICES SPECIFICATION
1. TO GUARANTEE THE REQUIRED VOLTAGE AT THE RELEASING DEVICE, THE FOLLOWING TABLE SHALL BE USED.
EX: TO DETERMINE THE TOTAL LOOP LENGTH, MEASURE THE DISTANCE BETWEEN THE CONTROL HEAD AND THE
CONTROL PANEL TERMINAL BLOCK, THEN MULTIPLY BY TWO.
CONTINUOUS
MOMENTARY
CONTINUOUS
CONTINUOUS
MOMENTARY
CONTINUOUS
CONTINUOUS
"ON" TIME
420 mA
240 mA
440 mA
I max.
458 mA
700 mASOLENOID
GROUP
48650001
81-100000-001
81-100000-001
FM
B,D
E,G
A
899175
890181
DEVICE
2.4 A
2.4 A
34 OHM
57 OHM
103 OHM
59 OHM
52 OHM
RESISTANCE (min.)
10.8 OHM
10 OHM
3.
L
S
- FOR SUPERVISED CIRCUITS
- FOR POWER LIMITED CIRCUITS
4. The following releasing device configurations are possible:
(1)One Kidde Solenoid Control Head wired to Release terminals R2-/R1+.
(2) One Kidde Solenoid Control Head wired to Release terminals R1-/R1+ and R2-/R2+ respectively.
(3) One Kidde Solenoid Control Head wired to Release terminals R2-/R1+ plus one Kidde Solenoid
Control Head wired to Stop Valve terminals Stop V-/Stop V+.
(4) Two Kidde Solenoid Control Heads wired to Release terminals R1-/R1+ and R2-/R2+ respectively
plus one Kidde Solenoid Control Head wired to Stop Valve terminals Stop V-/Stop V+.
(5) One FM Deluge/Pre-Action solenois wired to Release terminals R2-/R1+.
(6) One Kidde Solenoid Control Head wired to Release terminals R2-/R1+ plus one FM Deluge/
Pre-Action solenois wired to Stop Valve terminals Stop V-/Stoop V+.
firealarmresources.com