Some generators and/or AGS have settings for 2 minute, 2 hour and 24 hours (or similar duration) start
voltages. They set time limits the battery voltage can sit at before activating the generator. They are
related to the Low Voltage Disconnect/Cut-Off voltage and the Recharge/Re-bulk voltage. Expect to adjust
any or all of them over time to get exactly the generator behavior you wish. Depending on the make and
model of the generator or AGS, you may need to have more spacing between these settings.
● 2 minutes - Set just above the inverter/charger Low Voltage Disconnect (12.25 V) so the generator
starts before the inverter stops inverting.
○ Start at approx. 12.3 V and adjust as necessary.
● 2 hours - Set above the 2 minutes volts.
○ Start at approx. 12.4V.
● 24 hours - Set just below the Recharge/Re-bulk voltage. If the Recharge/Re-bulk setting hasn’t
already started the generator at this time, the generator will start.
○ Start at approx. 12.7 V if Recharge/Rebulk is 12.75 V.
4.5 - HLX iT Bluetooth Mobile Application
4.5.1 - Introduction
Disclaimer:
The KiloVault® Bluetooth® mobile application is provided as is and is solely
intended to gather general information. It is not intended to replace a
voltmeter, ammeter, or any other testing / measurement device. Nor is it
guaranteed to work with every mobile device.
The KiloVault® HLX iT smartphone Bluetooth® app enables you to view general information about the
selected individual battery. It can help troubleshoot when attempting to detect the cause of the battery
bank going off-line. The app is available as a free download for both Android and iOS devices on the iOS
and Google Play app stores.
Your Android / iOS mobile device must support Bluetooth® 4.0 and Bluetooth® Low Energy (BLE). The iOS
version requires iOS 10.0 or later and is compatible with iPhone, iPad, and iPod touch. The Android
version requires Android 4.3 (Jelly Bean) and up. Additionally, the Android version must have permission
to access both Location and Local Storage.
4.5.2 - Screens & Operation
When you first start HLX iT, if you have bluetooth enabled, the screen will show all of the HLX batteries
within a 100m radius, depending on the physical or electrical interference.
KiloVault
®
LLC • 330 Codman Hill Road, Boxborough, MA 01719 • +1 (888) 218-5924 • info@kilovault.com • www.kilovault.com
Revision 1.0, 06/2021
Page 14 of 29
To Next Page
Loading...
Need help?
General
