Version 1.1 © Changsha KILOVIEW Electronics CO.,LTD. All rights reserved
HD Video Encoders · User Manual
2 Operation guidance
Installation and connection of the device
Connect the power and video input source correctly, power on the device.
Network Connection and Configuration
If you want to set up the network manually, when using wired connection mode, you can use the device
failsafe IP address (192.168.1.168) to login the WEB page for setting up; At the same time, for
convenience of operation, you can also connect the device's own WIFI hotspot to configure device
through other WIFI terminal, such as mobile phone or pad. If you use the wireless network push flow,
you must first log on to the device web Page to set up WIFI.
RTSP pull flow
The decoder's RTSP stream is directly pulled using a decoder or a PC-side player (such as VLC), and the
RTSP stream service is continuously turned on.
Other streaming service
If necessary, you can also configure the device to push video streams such as RTMP, RTMPS, UDP, HLS,
etc.
To Next Page
Loading...
Need help?
General
