Copyright © Changsha KILOVIEW Electronics CO.,LTD. All rights reserved
N3 for NDI·
After login, the encoding and function parameters can be set on the encoder management
web page. The page is shown as below:
5.2 Network Configuration
The Ethernet port of the device is connected through the network cable and it can be
configured with an IP address. The device network port can be configured with dual IP
addresses. The IP address configured here is not the default management IP address. The
Ethernet port defaults to DHCP to obtain an IP address. It will automatically obtain a
complete IP address, Gateway and DNS according to this LAN.
Click “Network” to view the device Ethernet address configuration and Failsafe address
The Failsafe address is the default management IP address. Generally, you do not need to
make special settings.
To Next Page
Loading...
Need help?
General
