Copyright © Changsha KILOVIEW Electronics CO.,LTD. All rights reserved
N3 for NDI·
Audio source:you can select SDI embeded audio (by default) or analog input.
Analog audio input can be encoded as audio source, or for intercom (Note: Voice
intercom not realized in the version).
Volume: For gain adjustment of input line-in audio or SDI embedded audio.
Encoding quality: When the encoding quality is reduced/increased, the encoding
quality and encoding bitrate will also be lowered/increased.
Note
:
It’s not required to save after modifying the device group, device name and channel
name. After the modification, it will take effect immediately if clicking on other places on the web
page.
7.3 Advanced settings
7.3.1 NDI Connection
If choosing multicast mode, NDI transmission will be executed in multicast mode. Click
“Generate”, a multicast IP will be generated randomly, or you can configure it manually
and click “Apply” to take effect.
7.3.2
PTZ control
The device supports PTZ control, both protocol types of PTZ over Ethernet and serial port
are supported.
PTZ over Ethernet needs to correctly configure the protocol address and port of the
connected PTZ, and specify the PTZ control protocol (Sony Visca, Pelco-D/P supported).