Copyright © Changsha KILOVIEW Electronics CO.,LTD. All rights reserved
N3 for NDI·
When you need to search for NDI sources across network segments, if the group name is a
non-public group, you need to fill in the specified group name firstly, and then fill in the
specified IP address in the "IP" box, click the button , this IP address will be added to
the "Manual Scan Address List". You can add multiple IP addresses to search at the same
time, and then press "OK" to save.
8.2 Decoding and output
You can add up to nine preset decoding sources, by clicking the NDI sources, the device
will start decoding the corresponding NDI source. It can be quickly switched and decoded
by clicking different NDI sources. By clicking x in the upper right corner of the NDI
source in the preset box, you can delete the added source.
There is a blank output box in decoding preset, if switching to a source without video
output, the device will output the set color. It can also be used for testing the output to the
monitor by choosing different color.
To Next Page
Loading...
Need help?
General
