Copyright © Changsha KILOVIEW Electronics CO.,LTD. All rights reserved
N3 for NDI·
2 USER GUIDE
Installation and Connection
Connect the power and video input source correctly, power on the device.
Network Connection and Configuration
The easiest way for network connection is to connect the device to the network by wire,
automatically obtain the IP address and DNS from the network without any settings on the
device. After that, use NewTek Studio Monitor and connect the NDI stream of the device,
click the gear button ( ) in the lower right corner of the software interface, you can
directly open the login link of the encoder WEB page without manually entering the URL.
(For the first login or the first login after restoring the factory settings, you will need to
agree to the “EULA” that pops up. Otherwise, the NDI stream service of the device
cannot be used normally.)
If you want to set the network manually, you can use the default IP address 192.168.1.168
to login the web page and set. The default username and password are “admin/admin”.
NDI Streaming
NDI has the function of automatic discovery. After the encoder is normally connected to
the network, other NDI-supporting tools (such as Newtek studio monitor, OBS, vMix) can
automatically discover the encoder and pull the NDI stream directly.
NDI Decoding
You can switch to the decoding function on the Web page. The device can automatically
discover NDI sources in the same network segment, and select the source to decode and
output to the monitor. You can also decode and output by means of manually adding NDI
sources across network segments or NDI sources from non-default group.
To Next Page
Loading...
Need help?
General
