R ev . 11/ 20 10 Pag e 4 P roduc t N o. 14 19 7
meter disc
Make sure pawls and
springs are back before
inserting new meter disc
Use of an external 3-valve by-pass or equivalent is
recommended.
Set number of gallons between regenerations based on your system size and inlet water quality (see step 10).
Connect softener to main plumbing via by-pass.
Do not solder brass adapters while they are inserted
in the control module.
Take care during the installation process to assure
that solder and flux do not come in contact with:
media tanks
control module
E-clips
related plastic components
Gently turn disc clockwise until
pawls fall in place
Replace oring, spring,
actuator and cap
To Next Page
Loading...
Need help?
General
