Kinetico KPRO COMPACT - 3.3 Functionalities

12
after reset.
6. Start the Device.
The system starts up normally.
During the first 30 seconds, the water
quality light shows the latest quality sta-
tus and is always on.
For the next 30 seconds, the water
quality light displays real-time quality
data and is always on.
8. Turning on the
system.
The system starts up. After connecting the power supply, a
beep sounds and all the lights turn on
and blink at the same time, changing
from blue to purple to red. Each colour
is displayed for 1 second.
7. Stop the device.
The system stops producing water and
goes into standby.
The water quality light turns off.
3.3. FUNCTIONALITIES
FUNCTION
ACTION
STATUS OF THE LIGHTS
1. Functional flushing
The machine will flush the RO membra-
During washing, the water quality light is
for the first use or
ne for 5 minutes.
flashing at 1Hz.
2. Flushing when tur-
Whenever the system is started it will
When flushing is in progress, the water
ning on the machine.
flush the RO membrane for 20 seconds.
If the user use Water, the machine will
stop flushing and go into normal mode.
quality light shows the previous on sta-
tus.
3. Flushing when
Every time the accumulated working
When flushing is in progress, the water
accumulating opera-
time reaches 2 hours, the system will
quality light shows the previous flushing
ting time.
flush the membrane for 20 seconds.
If the user use Water, the machine will
stop flushing and go into normal mode.
status.
4. Daily flushing.
When the machine has not been run-
ning for 24 hours, the system will flush
the membrane for 20 seconds. If the
user use water, the machine will stop
flushing and go into normal mode.
When washing is in progress, the water
quality light shows the previous flushing
status.
5. Flushing after filter
CF: By changing the CF pre-filter and
When the CF pre-filter or RO membra-
change.
resetting its usage counter, the system
will initiate a flushing of the CF filter and
RO membrane for 5 minutes.
ne is being flushed, the water quality
light shows red and will flash at 1Hz.
RO: By changing the RO membrane and
resetting its usage counter, the system
will start a 5 min flush. There will be a
low Flow during this process.