Low temperature
protection
OFF OFF
Blink red 1 Hz Blink Purple 1 Hz
3.4.
BUG IDENTIFICATION AND RESOLUTION
When the leak is eliminated, the alarm
is deactivated and it returns to the nor-
mal state.
2. Protection by pump
time.
CF and MRO indicator
flashing red
The pump has been working between
30 and 33 minutes. Disconnect and re-
connect the electrical connection
3. Protection by pump
start
/
stop.
CF and MRO indicators
flashing in purple
Disconnect and reconnect the electri-
cal connection.
4. Low temperature
protection.
Water quality indicator
and CF flashing n red
Disconnect and reconnect the electri-
cal connection.
When you detect that the equipment is in
any states described, contact the mainte-
nance Service to make an appointment to
or displaying carry out the required mainte-
nance alarm.
See the corresponding section in the tech-
nical manual.
Contact our technical service if the equip-
ment does not stop production after seve-
ral hours of continuous operation, without
extraction of water.
Contact your technical service if the equi-
pment is repeatedly blocked due to lack of
mains water pressure at the entrance to it
and there is pressure in the rest of the ne-
twork.
Contact your technical service if after using
water the equipment is not dispensing water
to the device without any type of alarm.
Contact your technical Service to reset
counters after changing the filters.
3.5.
FILTER LIFETIME DISPLAY
TIME OF LIFE
REMAINING (DAYS)
LITERS
OF CAPACITY
REMAINING
Double beep when the-
re is little time of life of
the filters.
Beeps when water is
dispensed.
3.6.
STATUS OF THE SYSTEM
To Next Page
Loading...
