Kingon P2 - Troubleshooting

Troubleshooting
Ⅳ
.TROUBLESHOOTING
The table below lists some common problems and actions you can take. If you can’t
resolve a problem, please contact your equipment provider.
Problem
Possible Cause
Recommended Solution
Device Won’t
Turn On
Battery is not
installed correctly
Remove the battery and re-install it
correctly.
Battery is depleted.
Use the AC or DC power adapter to
operate the device (with the battery
inserted) to recharge the battery
.
If this
does not resolve the problem, contact
your equipment provider.
the AC supply is poor
contact.
Check power supply connection and
verify green light on adapter is solid.
the DC adapter is not
connected properly
Check DC adapter connection
No Oxygen
The device is not
turned on.
Turn on the concentrator.
Cannula is kinked or
obstructed.
Check cannula and its connection to the
oxygen outlet port.
Equipment failure.
Contact your equipment provider
.
Oxygen Not At
Full
Concentration
The device is
warming-up.
Wait 2 minutes for the device. If the
problem is not solved, please contact
your equipment provider.
The sieve beds may
require servicing.
Contact your equipment provider to
change the sieve beds.
Alarm Occurs
Refer to Previous
section-Alerts.
Refer to Previous section -Alerts.