Kingon P2 - EMC Information-Continued

System Specifications
31
EMC Information-Continued
Guidance and Manufacturer’s Declaration –Electromagnetic Emissions:
The Concentrator is intended for use in the electromagnetic environment specified
below. The user of the Concentrator should make sure it is used in such an environment.
Emissions Test
Compliance
Electromagnetic Environment -
Guidance
RF Emissions
CISPR 11
Group 1
The Device uses RF energy only for
its internal.
Function. Therefore, its RF emissions
are very low and are not likely to
cause any interference in nearby
electronic equipment.
RF Emissions
CISPR 11
Class B
The Device is suitable for use in all
establishments, including domestic
establishments and those directly
connected to the public low-voltage
power supply network that supplies
buildings used for domestic
purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage
Fluctuations/Flicker
Emissions IEC
61000-3-3
Complies
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
Radiated RF
IEC 61000-4-3
3 Vrms
150 kHz to
80 MHz
6 Vrms
Amateur
Radio &
ISM Bands
between
150 kHz and
80 MHz
10 V/m
80 MHz to
2.7 GHz
3 Vrms
150 kHz to
80 MHz
6 Vrms
Amateur Radio
&
ISM Bands
between
150 kHz and
80 MHz
10 V/m
Portable and mobile RF
communications equipment
should be used no closer
to any part of the Device,
including cables, than the
recommended 30 cm
separation distance.
Interference may occur in
the vicinity of equipment
marked with the
following symbol: