Maintenance and Cleaning of Kingon P2
Intake Filter # FI-P201
The intake filter is designed to ensure the clean air into the compressor.
1.screw off the screw on the bottom of pre-filter by a Philips
screwdriver.Lift the particle screen up by the bottom end then remove it.
2.take out of the intake filter from the intake chamber;
3.put a new intake filter into the chamber;
4.Install pre filters.
Pre and intake filters can be purchased from your equipment provider.
Battery Care and Maintenance
The Kingon P2 Lithium Ion Battery requires special care to ensure proper performance
and long life. Use only KingonP2 batteries # BA-P200 with your concentrator.
Keep liquids away from batteries.
If batteries become wet, stop use immediately and dispose
of battery properly.
Battery Replacement
1.Press down the latch ,and flat slide the battery off
2.Insert the Kingon P2 battery by sliding battery into place until the latch returns to the
upper position.
To Next Page
Loading...
