UNITY, NO DECAY
NO REPEATS,
INSTANT DECAY
L
O
O
P
D
E
C
A
Y
S
F
A
S
T
E
R
T1 — Controls volume decay over time. Remember that
Touch must be engaged for your loop to decay. If
disengaged, it will maintain its current volume.
There are two options to record to the loop:
• Hold down Touch to record, then release to stop.
• Tap briey to start recording, then tap again to stop.
The rst write sets the loop length. The Touch LED will
ramp from zero to 100% brightness as your loop plays
from start to nish. Touch works like a write head,
and when you engage it a few things happen:
• You are recording, so you can overdub new audio.
• Your loop can decay in volume.
• Your loop disintegrates. Each time your loop repeats
it gets re-run through all of the stereo tape eects.
This provides many unique ways to slowly change and
degrade your loop.
Try loading the Init preset before using this Touch
Mode for the rst time. Then you can slowly dial in
tape eects while Touch is engaged to explore how
they impact your loop over time.
22
To Next Page
Loading...
