Kinotone ribbons - Mix and Utility Controls

MIX (MX) — Ribbons has a dedicated mix knob for all of
its sounds and eects. This is thoughtfully designed so
that so you can blend dry and wet signals without any
phasing issues.
The main use case for this knob is to use it in conjunc-
tion with the dierent modulation settings. For example,
at 100% mix you can get a tape-like vibrato, at 50% a
lush chorus, and at zero you’ll get no eects at all —
just your dry signal.
LOW-PASS MIX
COMPRESSION
SATURATION
HIGH-PASS
Mix and UtilityPage 1
LOW-PASS (LP) — A slightly resonant four-pole virtual
analog low-pass lter. Rotating the knob counter-
clockwise removes treble and brightness from your
signal.
HIGH-PASS (HP) — A symmetrical and opposite high-
pass lter. Rotating the knob clockwise removes bass
and boominess from your signal.
6