You don’t lose your settings when jumping
from one page to another.
All of Ribbons’ parameters work together, so dialing
in your desired eect is a matter of adjusting the
knobs on each page.
If you’re ever not sure what the heck is going on and
just wish you could start over — no worries.
Load up preset 1 to reset the tape eects to a
completely transparent state (see page 13).
Powering o and on won’t help, since Ribbons
Remembers your last used settings between power
cycles, including which page you were on.
Relative knobs
When you switch pages, the physical position of a knob
and its parameter may be momentarily misaligned.
When this occurs, controls are responsive in a relative
way, meaning that the knob will attenuate or increase
the parameter based on the actual amount of space
that’s available. Once they match up, the knob will start
tracking again as you'd expect.
This sounds a bit complicated but it’s actually really
simple, and you should get a feel for it pretty quickly by
watching the LEDs.
!
5
To Next Page
Loading...
