Kinotone ribbons - Presets; Factory Preset Management

13
Presets
Presets are a quick way to queue up some core sounds
Ribbons is capable of. To enter the Presets Menu, hold
down the push button for 3 seconds. A single LED will
light up, and now you can toggle through 8 preset slots:
1, 2, 3, 4 are red, and 5, 6, 7, 8 are blue.
To load a preset, hover over a slot and press Touch.
The LEDs will all glow, and now you can hear the sounds
of that preset aecting your incoming audio.
Factory presets:
If you load up a preset and then press the push button
or turn a knob, you are back to editing tape eects
with that preset as the starting point. So if you’re
jamming with one preset and want to try out a dierent
one, you rst have to re-enter the Presets Menu.
To overwrite a preset with your current settings, enter
the menu and hover over the slot you want to use. Press
Bypass twice to conrm and save. To exit without
loading or saving, simply hold down the push button
again for 3 seconds.
Our online manual describes settings for each factory
preset. If you ever nd yourself wanting to restore them,
check out the factory reset option on page 29.
1
2
3
4
5
6
7
8
Init (no eects; transparent)
Chaotic Vibrato
Chaotic Chorus
A Bit Lo-Fi
Crushed and Mangled
Really Nice Compression
Lo-Fi Ambient
Endless Reverb