Kinotone ribbons - Reverb and Touch Modes Introduction

Page 4 has controls for the reverb, as well as the Touch
Modes. A good way to remember this last page is:
red for reverb, hand for touch.
Ribbons’ reverb algorithm draws inspiration from the
famous rack reverb units of the 70’s and 80’s. We
carefully studied many of these designs and came up
with our own unique structure that’s simple, elegant,
and modern sounding. It’s a versatile tool, especially
when used in combination with the other tape eects.
REVERB MIX & PLACEMENT (RM) — Both mix and
placement are on the top-left knob, so you can control
the amount of reverb applied, and where it goes in your
signal chain, either before or after the other eects.
Reverb, Touch ModesPage 4
REVERB MIX
& PLACEMENT
TOUCH 1
TOUCH 2REVERB DECAY
11